iPhone 12 Pro Motherboard Repair in Al Khobar

iPhone 12 Pro Motherboard Repair in Al Khobar fixes a phone that won't power on, restarts or runs hot. We test the board free and find the faulty part under a microscope. Then we replace only that part, not the whole board, and we keep your data wherever we can.

An iPhone 12 Pro not turning on is the sign that brings most people in. The screen stays black, and the phone doesn't buzz or warm up on the charger. Other phones restart every few minutes, lose signal or get hot while switched off.

It's better not to wait. A short keeps heating the parts around it, even when the phone looks dead. Water left inside keeps eating the board, so every day makes the repair harder.

Not every dead phone has a board fault. A flat battery, a loose screen cable or a blocked port can look exactly the same. We test those first, so you only pay for the repair you need.

When the fault is on the board, we look closer. The iPhone 12 Pro motherboard has two thin layers stacked together, packed with tiny parts. Often one small chip or joint has failed, and we replace just that.

How Kabayan Center Repairs an iPhone 12 Pro Motherboard

We fix these board faults on this phone.

• No power at all, even on the charger
• Restarting again and again, or stuck on the logo
• No signal or no service after a drop
• No charging, even with a good port and battery
• A phone that gets hot while it's switched off
• Faults that start after water, sweat or a spill

Here is how an iPhone 12 Pro motherboard repair works with us, step by step.

1. We check the phone free and test the battery, screen and port to rule them out.
2. We connect a power meter that shows how much current the board pulls.
3. We tell you what we found, and you decide before any work starts.
4. We open the phone from the front, disconnect the battery and lift out the board.
5. We find the faulty part under a microscope, using the meter and a little heat.
6. We replace that part with a fine hot-air tool and a soldering tip.
7. We rebuild the phone, test power, charging, signal and cameras, then let you check it.

Have a different phone or a laptop? Our motherboard repair service covers other devices too. Customers come to our shop on King Fahd Road from Dammam and Dhahran as well.

Why an iPhone 12 Pro Board Fails: 3 Real Cases

A gas-station car charger that caused a short

A customer came to us after a long drive between cities. They had bought a car charger at a gas station on the way. Halfway home, the phone went black on the charger and never came back.

"It's not even warm," they said. They had searched for iPhone Motherboard Repair in Al Khobar the next morning.

A poor charger can send a spike of power into the phone. We connected the power meter and saw the board pulling a short the moment the battery went in. Under the microscope, one tiny part near the power line had a burnt top.

We finished the iPhone 12 Pro motherboard repair, and the phone started up with all its data. But charging was still weak with our cable. The same spike had scorched two pins in the Lightning port.

So we also did a charging port repair, fitting a new port cable. After that, the phone charged at full speed.

We suggested buying car chargers from a known shop and keeping the receipt. A good charger costs far less than a board repair. It also keeps the battery and port safe on long drives.

Sea water on a fishing trip, brought in fast

This one starts on a small boat off the coast. A wave splashed over the side, and the phone slid into the water at the bottom of the boat. It switched off a few minutes later.

The owner had looked up mobile repair in Al Khobar from the dock. They didn't try to charge it, and they didn't put it in rice. They brought it straight to us that same evening.

Salt water is the hardest kind for a board. It conducts power and starts rust within hours. We opened the phone and found salt across one layer of the board, with no green crust yet.

We did a water damage repair, separating the layers and cleaning both in a special bath. Then we dried the board and checked every line under the microscope.

The phone turned on with its photos and chats in place. Signal, cameras and charging all passed our tests.

Coming in fast saved this board. A day later, the salt would have started eating the tiny parts. The owner now keeps the phone in a dry bag on the boat.

Restarts after a battery swap somewhere else

We often see this after a quick repair done in a hurry. A student had a new battery fitted at a small stall. Soon after, the phone began restarting every few minutes.

"It's a brand new battery, so why does it keep doing this?" the student asked.

We opened the phone and looked at the battery connector on the board. Some of its tiny pins were bent, and one had lifted off. Someone had pried the battery out instead of pulling its stretch tabs.

Under the microscope, we did the iPhone 12 Pro motherboard repair by rebuilding the lifted pin with fresh solder. The restarts stopped straight away, and a long test ran clean.

But the battery fitted at the stall had a low health reading. It wasn't swollen, so it was safe to use. The student chose to keep it for now and plan a phone battery replacement later.

So the phone is stable, but it still runs down a little early. We noted that on the job card. A careful battery job the first time would have saved the board, and the student's time too.

How to Keep Your iPhone 12 Pro Board Safe

• Use a good charger and cable, and avoid unknown car chargers.
• Never charge a phone that got wet, and skip the rice. Bring it in fast instead.
• Keep the phone in a dry bag on boats and at the beach.
• Use a case with thick corners to soften drops onto tiles.
• Choose a careful repair, since a pried battery can lead to an iPhone 12 Pro motherboard repair.
• Back up your photos and chats every week, so a board fault never costs you your files.
• Get phone repair in Al Khobar as soon as the phone restarts by itself or warms up while off.

Related services

• Data recovery for photos and files on a phone that won't turn on