iPhone 6S Plus Charging Port Repair in Al Khobar

iPhone 6S Plus Charging Port Repair in Al Khobar gets a loose or dead port charging firmly again. We check the Lightning port free, then clean it or replace the port part. That part also carries the headphone jack and bottom mic, and most jobs are done the same day.

An iPhone 6S Plus not charging often starts small. The cable needs a push, then a certain angle, and then nothing works at all. Some owners also hear crackling in wired earphones, since the headphone jack sits on the same part.

Changing the cable is the usual first try, and a new charger is the second. It rarely helps, because the fault sits inside the phone. The good news is that the fix is often simple and quick.

It's better not to wait. A loose plug sparks a little and heats the pins, so they slowly burn. A battery that runs flat again and again also wears out much faster than it should.

Not every fault needs a new part. Dust, lint and grit cause most problems, and careful cleaning clears them. When the pins are bent, burnt or rusted, we replace the iPhone 6S Plus charging port part as one piece.

How Kabayan Center Repairs an iPhone 6S Plus Charging Port

We fix these charging faults on this phone.

• A loose cable, or charging only at one angle
• Charging that stops and starts
• No charging at all
• Slow charging with a good charger
• An accessory warning on the screen
• Crackling earphones, or a quiet mic on calls

Here is the repair, step by step:

1. We look into the port under a magnifier and test it with our own cable.
2. We tell you what it needs, and you decide before any work starts.
3. We clean out dirt with plastic tools and a soft brush.
4. If the pins are damaged, we open the screen from the bottom and unplug the battery.
5. We lift out the loudspeaker and the vibration motor to reach the port part.
6. We fit the new part and test charging, the headphone jack and the mic.
7. We close the phone and let you check it yourself.

Using a different phone? Our charging port repair service covers other models too. Customers come to our shop on King Fahd Road from Dammam and Dhahran as well.

Why an iPhone 6S Plus Stops Charging: 3 Real Cases

A broken cable tip stuck inside the port

One morning a phone came in with a tiny piece of metal inside the port. An unbranded cable had snapped while the owner pulled it out. The tip stayed stuck deep in the port.

"I tried to get it out with a needle," the owner admitted. That's common, and it made things worse. The needle scratched one pin and pushed the tip further in.

The owner had searched for iPhone Charging Port Repair in Al Khobar after the phone ran flat. Under the magnifier, we could see the broken tip and the scratched pin beside it.

We pulled the tip out with fine tweezers. The scratched pin no longer made good contact, so cleaning wasn't enough. The iPhone 6S Plus charging port repair used a new part, which also gave a fresh headphone jack and mic.

Charging was firm again with a good cable. We tested it with several cables to be sure, and each one clicked in cleanly.

The owner now buys cables with a solid plug and pulls them out by the plug. The needle went back to the sewing box.

Sweet tea spilled across the desk

A common office case: a cup of sweet tea tipped over on a desk. An accountant's phone was lying right beside it, port first. It still worked, so it went back on charge.

Within days, the plug felt sticky and the phone charged only sometimes. "It's like the cable is glued in," the accountant said. Sugar dries hard, and it holds moisture against the pins.

The accountant had looked up mobile repair in Al Khobar when the earphones started crackling too. We opened the phone and found sticky brown marks around the port part. The tea had also run onto the board.

So we did a water damage repair, cleaning the board in a special bath. Then we did the iPhone 6S Plus charging port repair with a new part, since two pins had rusted. Cleaning alone would not have saved them.

Charging, the headphone jack and the mic all tested clean afterwards. Any drink is worse than water, because sugar and milk leave a sticky layer. The earphones played clearly again.

The accountant now keeps the phone on a small stand, well away from cups. A cup lid helps too, on busy days.

Pins worn flat by years of nightly charging

We often see this with phones that charge every night for years. A hotel cook used the phone as an alarm and charged it beside the bed. Slowly, the plug grew loose and started falling out.

The cook thought the cables kept going bad and bought new ones. But the pins inside were worn flat from years of plugging in. A new cable can't grip worn pins.

We cleaned the port first, but the worn pins still didn't hold the plug. So the iPhone 6S Plus charging port repair needed a new part, and the cable clicked in firmly again.

While testing, the battery health showed very low. Years of full charges every night had worn it out. We suggested a phone battery replacement, but the cook chose to wait for now.

So the phone charges well again, but it still drains before the end of a long shift. We noted the battery on the job card for next time.

A port and a battery often wear out together on an older phone. Checking both at once can save a second trip.

How to Keep Your iPhone 6S Plus Charging Port Working

• Look into the port with a torch now and then.
• Never dig in the port with a needle, pin or toothpick.
• Buy cables with a solid plug, and pull them out by the plug.
• Keep drinks away from your phone on the desk.
• Never charge a phone after a spill until it has been checked.
• Get phone repair in Al Khobar as soon as the cable needs a special angle.

Related services

• Motherboard repair for a phone that still won't charge with a new port
• Phone screen replacement for a cracked or dark screen