iPhone 7 Plus Charging Port Repair in Al Khobar

iPhone 7 Plus Charging Port Repair in Al Khobar gets a loose or dead Lightning port working again. We check it free, then clean the port or fit a new port part. That part also holds the bottom mics, so we test calls too, and most jobs are done the same day.

An iPhone 7 Plus not charging often starts slowly. First the cable needs a push, then a certain angle, then nothing works. Some owners also hear that callers can't hear them well, since the mics sit beside the port.

This phone has no headphone jack, so the charging port does two jobs. Many owners plug earphones in through a small adapter all day. That means twice the plugging in, and the pins wear sooner.

It's better not to wait. A loose plug heats the pins and slowly burns them. A battery that keeps running flat also wears out early, which means a second repair later.

Not every fault needs a new part, since careful cleaning fixes most lint and dust problems. Bent, burnt or rusted pins mean we replace the iPhone 7 Plus charging port part. It sits under the loudspeaker and vibration motor, so we take those out first.

How Kabayan Center Repairs an iPhone 7 Plus Charging Port

We fix these charging faults on this phone.

• A cable that wobbles or slips out
• Charging only at one angle, or charging that stops and starts
• No charging at all
• Slow charging with a good charger
• Earphones that cut out through the adapter
• Callers who say you sound far away

Here is the repair, step by step:

1. We look into the port under a magnifier and test it with our own cable and earphones.
2. We tell you what it needs, and you decide before any work starts.
3. We clean out dirt with plastic tools and a soft brush, never metal.
4. If the pins are damaged, we warm the screen seal and open the screen like a book.
5. We unplug the battery, then take out the vibration motor and loudspeaker that cover the port part.
6. We finish the iPhone 7 Plus charging port repair and test charging, earphones and the bottom mics.
7. We fit a fresh seal, close the phone and let you check it.

Using a different phone? Our charging port repair service covers other models too. Customers come to our shop on King Fahd Road from Dammam and Dhahran as well.

Why an iPhone 7 Plus Stops Charging: 3 Real Cases

A bedside dock that bent the port

This one starts on a bedside table. A night-shift nurse charged the phone on a stand-up dock every day. The phone sat upright on the plug, and its weight pressed down on the port.

They had searched for iPhone Charging Port Repair in Al Khobar when the phone stopped charging on the dock. "It works with a cable, but only if I hold it," the nurse said. A big phone resting on a fixed plug bends the port a little each night.

Under the magnifier, the inside of the port had shifted to one side. Two pins were bent and dull. Cleaning would not fix it, so we opened the phone.

The iPhone 7 Plus charging port repair used a new part, and charging was firm again with a normal cable. The bottom mics tested clear on a call.

During the test, the battery health was also low. Charging in short, uneven bursts had worn it down. We explained a phone battery replacement would bring the full day back.

The nurse chose to change the battery on the next day off. So charging is firm now, but the phone still drains fast by evening.

We suggested a flat stand with a short cable instead of a fixed plug.

Cement dust that turned to paste

We often see this from building sites. A site supervisor carried the phone in a shirt pocket all day. Fine cement dust settled into every gap, including the charging port.

One hot afternoon, sweat soaked the pocket. The dust in the port turned into a hard paste. "The cable won't even go halfway," the supervisor said.

The supervisor had looked up mobile repair in Al Khobar and came in that evening. Under our light, the port was filled with a grey crust. The cable could barely touch the pins.

We softened the crust with a cleaning fluid and picked it out slowly with plastic tools. It took patience, since cement sets hard. Underneath, the pins were scratched but still working.

After cleaning, the cable clicked in firmly. The phone charged at full speed on the first try. The iPhone 7 Plus charging port repair needed no new part this time.

We also cleared dust from the speaker and mic holes beside the port. Calls sounded clear again.

The supervisor now keeps the phone in a zipped pouch on site. A soft port plug costs very little and keeps dust out.

Damp air at a beach chalet

A common surprise after a long beach stay. A family spent a week at a chalet near Half Moon Bay. The phone sat by an open window in damp, salty air every night.

Back home, it charged slowly and then stopped. Green crust showed deep inside the port. "It never got wet," the owner said.

Salt air settles as a fine, damp layer, and it eats metal pins over time. We opened the phone and found rust on the port part and white marks on the board nearby. So we did a water damage repair, cleaning the board in a special bath.

Then the iPhone 7 Plus charging port repair used a new part. Charging came back at full speed, and the mics tested clear.

Damp, salty air can harm a phone without a single splash. An ageing water seal lets it in a little more each night.

We suggested keeping the phone in a closed bag at the chalet, away from open windows. A quick look into the port after a beach trip helps too.

The owner now brings a small zipped case for every beach stay.

How to Keep Your iPhone 7 Plus Charging Port Working

• Use a normal cable instead of a stand-up dock that holds the phone's weight.
• Use wireless earphones if you listen for long hours, so the port only charges.
• Keep the phone in a zipped pouch on dusty sites.
• Never clean the port with a metal pin or needle.
• Keep the phone in a closed bag near the sea.
• Get phone repair in Al Khobar as soon as the cable feels loose.

Related services

• Motherboard repair for a phone that still won't charge with a new port
• Phone screen replacement for a cracked or dark screen