iPhone SE (2nd generation) Charging Port Repair in Al Khobar

iPhone SE (2nd generation) Charging Port Repair in Al Khobar fixes a phone that charges loosely or not at all. We check the Lightning port free, then clean it or fit a new port part. We test charging, the cable fit and the bottom mic, and most jobs are done the same day.

This phone is also called the iPhone SE 2020. An iPhone SE 2020 not charging usually starts with a cable that feels soft and loose. Then it charges only at an angle, or only when the phone lies flat on a table.

Many owners blame the cable first and buy a new one. When that fails too, they try a new charger or another socket. The real problem is usually inside the port.

It's better not to wait. A plug that keeps losing contact heats the pins and can burn them. The battery also runs flat again and again, and that wears it out early.

Not every fault needs a new part, since most blocked ports just hold lint, crumbs or sand. Bent, burnt or rusted pins are different. The iPhone SE 2020 charging port sits on a thin cable with a microphone, and we replace that cable.

How Kabayan Center Repairs an iPhone SE (2nd generation) Charging Port

These are the charging faults we fix on this phone.

• A loose cable, or charging only at one angle
• No charging at all, with any cable
• Charging that starts and stops by itself
• Slow charging on a good charger
• A message that the accessory is not supported
• A muffled voice on calls, since the bottom mic shares the part

Here is how our iPhone SE (2nd generation) charging port repair works, step by step.

1. We look into the port under a bright magnifier and test it with our own cables.
2. We tell you if it needs a clean or a new part, and you decide first.
3. We clear lint, crumbs and sand with plastic picks and a soft brush.
4. If the pins are damaged, we open the screen from the front and disconnect the battery.
5. We lift out the parts that sit over the port cable, such as the loudspeaker.
6. We fit the new port cable and test charging, the cable fit and the bottom mic.
7. We reseal the screen, check Touch ID and let you try your own cable.

Same trouble on another phone? Our charging port repair service covers other models too. Customers reach our shop on King Fahd Road from Dammam and Dhahran as well.

Why an iPhone SE (2nd generation) Stops Charging: 3 Real Cases

Crumbs at the bottom of a handbag

A common case starts in a handbag. A receptionist carried the phone loose in a bag with snacks, tissues and keys. "The cable won't go in all the way anymore," she said.

She had searched for iPhone Charging Port Repair in Al Khobar, worried the port was broken. The bottom of a bag collects crumbs and fluff. A port facing down scoops them up every time the phone drops in.

Under the magnifier, the port held a dark plug of crumbs and lint pressed hard against the pins. The cable could only reach the outer half of the port. No wonder the charging kept cutting out.

We broke up the plug slowly with a plastic pick and brushed it out. Underneath, the pins were clean and straight. The cable then clicked in firmly, and charging was fast again.

That iPhone SE (2nd generation) charging port repair needed no new part at all. The whole job took only a short wait at the counter.

We suggested a small zip pocket inside the bag just for the phone. Keys in the same pocket can also scratch the screen, so it helps twice.

Sea spray on a fishing trip

This one starts on a small boat. A fishing trip in the Gulf meant hours of sea spray and wet hands. The phone kept working, and it went on charge back at the dock.

Days later, it stopped charging and showed a warning about the accessory. "I wiped it dry on the boat," the owner told us. The owner had looked up mobile repair in Al Khobar after the warning would not go away.

Sea water is full of salt. It dries in the port and keeps drawing in moisture from the air. Charging through it then rusts and burns the pins.

We found white salt and green rust on the pins, with salt marks on the board nearby. So we did a water damage repair to clean the board first. Then we did the iPhone SE (2nd generation) charging port repair with a new port cable.

Charging came back strong, and the warning was gone. The bottom mic sounded clear in a test call too.

Never charge a phone that has been splashed with sea water. The owner now keeps it in a dry bag on boat trips.

A car charger that ran very hot

We often see this with no-name car chargers. A sales rep charged the phone in the car all day from a plug that got hot to touch. Over weeks, charging grew slower and slower.

"It takes all day to reach half," the rep said. A new cable had made no difference at all. The phone also felt warm in the car mount.

A poor car charger can send uneven power down the cable. That heat shows up first on the port pins, which turn dark. It can also stress the tiny chip on the board that controls charging.

Under the magnifier, two pins were dark with burn marks. We fitted a new port cable. The iPhone SE (2nd generation) charging port repair helped, but charging stayed slower than normal.

Our power meter showed the charging chip was not working at full strength. We explained that a motherboard repair would replace that chip.

The rep chose to wait, since the phone now charges overnight without trouble. So the port is new, but charging is still a little slow. The rep threw away the hot car charger that same day.

How to Keep Your iPhone SE (2nd generation) Charging Port Working

• Keep the phone in its own zip pocket, away from crumbs and keys.
• Look into the port with a torch every few weeks.
• Use a good car charger that stays cool, and replace one that runs hot.
• Never charge a phone that's wet or splashed with sea water.
• Clean the port only with a soft plastic pick, never a metal pin.
• Pull the cable out by the plug, not the wire.
• Get phone repair in Al Khobar once charging needs a special angle.

Related services

• Phone battery replacement for a phone that drains fast after months of poor charging
• Phone screen replacement for cracked glass or a dark display