Samsung Galaxy S23 FE Charging Port Repair in Al Khobar

Samsung Galaxy S23 FE Charging Port Repair in Al Khobar fixes a phone that won't charge or charges loosely. We check the port free, clean it if that's enough, or fit a new port board. We test fast charging and the microphone, and most jobs are done the same day.

A Samsung S23 FE not charging usually starts small. The plug feels loose, and charging stops when the cable moves. Later the phone says it's charging, but the level doesn't go up.

It's better not to wait for it to fail fully. Wiggling the plug every day wears the pins further and can bend them. If the battery runs flat and stays flat for days, it can also get weaker.

Not every fault needs a new part. Most ports are simply packed with lint and sand from pockets and bags, and a careful clean fixes them. A worn cable or charger can look like a bad port too, so we test those first.

The Samsung S23 FE charging port sits on a small board at the bottom, with the microphone. A thin flex cable joins it to the main board. When the pins are worn, bent or rusted, we replace that small board, not the whole phone.

How Kabayan Center Repairs a Samsung Galaxy S23 FE Charging Port

We fix these charging faults on this phone.

• A plug that feels loose or falls out
• Charging only when the cable is held at one angle
• A moisture warning when the port is actually dry
• Fast charging that stopped, so a full charge takes hours
• A phone that doesn't show up when plugged into a computer
• Callers who can't hear you, because the microphone shares the port board

Here is how a charging port repair works with us, step by step:

1. We check the phone free with our own tested cable and charger.
2. We look inside the port with a magnifier and gently clean out lint and sand.
3. We tell you if cleaning is enough or a new port board is needed, and you decide.
4. We warm and lift the back glass, then remove the loudspeaker to reach the port board.
5. We fit the new port board and connect its flex cable to the main board.
6. We seal the back glass with a fresh water seal.
7. We test charging, fast charging, calls and the microphone, then you check it yourself.

Own a different phone or a laptop? Our charging port repair service covers them too. Customers come to our shop on King Fahd Road from Dammam and Dhahran as well.

Why a Galaxy S23 FE Stops Charging: 3 Real Cases

Plugged in and pulled out every day for years

A security guard on night shifts came to us with a phone that charged only at one angle. "I rest it on a book to keep the cable just right," the guard said. The phone had been plugged in and pulled out every day for years.

Every plug wears the springy pins inside a little. Over time they stop gripping the cable. That's why the phone charged only when the cable was pressed to one side.

The guard had searched for Samsung Charging Port Repair in Al Khobar during a quiet night. We cleaned the port first, but the pins were plainly worn. So we did a Samsung Galaxy S23 FE charging port repair with a new port board.

The plug clicked in firmly after that. But our test showed a second problem: the battery was also badly worn from years of daily charging. It dropped fast, even on the new port.

We did a phone battery replacement while the phone was still open. The guard now charges it on a flat table, and the cable no longer needs a book to hold it.

Charged in a steamy bathroom

This one starts in a small flat with no window in the bathroom. A student charged the phone on the washbasin every morning during a hot shower. It played music the whole time.

Steam settled inside the port every day. After a few months, the phone showed a moisture warning and refused to charge. "But it's completely dry," the student told us.

The student had also tried a hair dryer on the port, which only pushed the steam deeper. Looking in, we saw green crust on the pins, and a little on the port board around them.

Moisture plus power turns into rust fast. We fitted a new port board, then checked the main board under a microscope.

Rust had started near the flex connector, so a water damage repair clean came next. It stopped the rust before it reached anything else.

The moisture warning went away, and the phone charged normally again. We also explained that a wet port should never go on charge. The student now leaves the phone in the hall and plays music on a small speaker instead.

A metal chip from a toolbox pocket

We often see this with people who work with their hands. A mechanic kept the phone in the same pocket as small screws and metal clips. One day the phone got hot at the bottom, gave a burnt smell and stopped charging.

The mechanic looked up mobile repair in Al Khobar at lunch and came straight over. Inside the port, we found a tiny metal chip stuck between the pins. Metal in a port can join two pins and cause a short circuit.

We took the chip out, but one pin was bent and burnt at the tip. So we fitted a new port board. Never dig in a port with a pin or a toothpick.

Cable charging worked again, but wireless charging didn't. The short had also damaged a small power part on the main board, which needs a motherboard repair.

The mechanic chose to use cable charging only, for now, and keep the board work for later. The phone works every day on the cable. That pocket now holds only the phone, and the screws live in a small box.

How to Keep Your Galaxy S23 FE Charging Port Clean

• Keep the phone in a pocket of its own, away from keys, coins and sand.
• Plug and unplug the cable straight, never at an angle.
• Charge outside the bathroom and away from steam.
• Use a good cable, and replace it when the plug gets loose or the wire splits.
• Charge wirelessly for a while if the port gets wet, instead of plugging in.
• Use a soft, dry brush for light dust, never a pin or a toothpick.
• Bring it for phone repair in Al Khobar as soon as the plug starts to feel loose.

Related services

• Phone screen replacement for a cracked or dark screen