Samsung Galaxy S24 Motherboard Repair in Al Khobar

Samsung Galaxy S24 Motherboard Repair in Al Khobar brings back a phone that won't turn on, restarts or overheats. We check it free, then trace the fault to one part on the main board. We repair that part and test the whole phone, and your data stays safe whenever the board allows it.

A Samsung S24 not turning on is the most common sign. The screen stays black, even on the charger, and nothing happens when you hold the power key. Other phones restart again and again, get very hot, or lose the mobile signal.

The Samsung S24 motherboard is the phone's main board. It holds the processor, the memory and the small parts that share out power. When one of those parts fails, the whole phone can stop.

It's better not to keep pressing the power key or leave it on the charger. A short circuit heats up and can damage more parts around it. The sooner we see it, the better the chance of saving your photos.

Some faults aren't the board at all. A dead battery or a broken charging port can look exactly like a dead phone, so we test those first. A real board fault needs careful work on one tiny part under a microscope.

How Kabayan Center Repairs a Samsung Galaxy S24 Motherboard

We repair these board faults on this phone.

• No power at all, even on the charger
• Stuck on the logo, or restarting again and again
• A phone that gets hot while doing nothing
• No mobile signal or no SIM found after a drop or water
• No charging, even with a good port and battery
• Damage from water, heat or a faulty charger

This is how we work on the board, step by step.

1. We check the phone free and test the battery, the charging port and the screen first.
2. We tell you what we found, and you decide before any work starts.
3. We lift the back glass, unplug the battery and take the main board out of the frame.
4. We power the board from a bench supply, which shows us how much power it draws.
5. We find the shorted or failed part with a heat camera and a microscope, then replace it.
6. We put the phone back together with a fresh water-resistant seal.
7. We test power, charging, signal, cameras and heat under load, then you check it yourself.

For other phones and laptops, our motherboard repair follows the same careful steps. Our shop is on King Fahd Road, and we get board jobs from Dammam and Dhahran too.

Why a Galaxy S24 Stops Turning On: 3 Real Cases

Left on the dashboard in peak summer

This one starts in a parked car at midday. A site engineer left the phone on the dashboard during a long site visit. When they came back, it was too hot to hold and had switched itself off.

By the next morning, it wouldn't turn on at all. The engineer searched for Samsung Motherboard Repair in Al Khobar and brought it straight in. "It was fine this morning, then just nothing," they told us.

On the bench supply, the board drew far too much power the moment we connected it. The heat camera led us to a small power part near the battery connector, glowing warmer than everything else. The heat had cracked it inside, and it was shorting.

We replaced that part under the microscope, and the phone started up. But it still shut down early, and the battery was slightly puffed. A swollen battery isn't safe, so we also did a phone battery replacement.

Now the phone works normally, with every photo still on it. The engineer keeps it in a bag on the car floor these days, out of the sun.

Dropped in a bucket while washing the car

A customer came to us holding the phone in a bag of rice. It had fallen into a bucket of soapy water during a car wash at home. They found us by searching mobile repair in Al Khobar after a night of waiting.

They had pressed the power key many times, hoping it would start. Rice doesn't dry the inside of a phone, and power tries can spread the damage. Inside, we found soap marks and green rust around the power parts and the SIM tray.

The customer cared most about photos of the children. So before anything else, we did a data recovery, copying the photos while the board still started. Every album came off safely.

Then we did a full water damage repair, cleaning the board in a special bath. We replaced a few rusted parts, and the phone turned on and made calls again.

The result was only partly good. The phone still restarted whenever the camera opened, because rust had reached under a large chip. The customer kept the photos and chose to use the phone as a spare.

A no-name fast charger

We often see this after someone buys a new charger. A student ordered a no-name fast charger online, because it was much faster than the old one. One night the phone got hot on charge and went black.

In the morning it was dead, with a faint burnt smell near the bottom. The student had tried several other cables and a different socket before coming in. None of them helped, and the phone stayed completely dark.

The charging port looked clean and undamaged. On the bench, the board showed a short on the power line that runs from the port. The charger had sent the wrong power, and a tiny part on that line had cracked.

We removed the shorted part and fitted a new one. The phone turned on at once, with the battery still half full. Charging worked at normal speed with a good charger.

We showed the student the cracked part under the microscope. A poor charger can cost far more than a good one. The student now uses a known charger, and the phone has run fine ever since.

How to Keep Your Galaxy S24 Board Safe

• Keep the phone out of a parked car in summer, even for a short stop.
• Use a good charger and cable from a shop you trust. A poor charger can send the wrong power.
• Turn a wet phone off at once and don't charge it. Skip the rice and bring it in.
• Stop pressing the power key if the phone won't start. Repeated tries can make a short worse.
• Back up your photos and chats often, so a board fault never costs you your memories.
• Take it for phone repair in Al Khobar if it gets hot while doing nothing. That's often an early board fault.

Related services

• Charging port repair for a phone that turns on but won't charge